UD Sifu B-Tab Box MOD & DIY Tool - бокс мод и рабочая станция для обслуживания атомайзеров.

UD Sifu B-Tab - это не просто мощный боксмод с температурным контролем, это еще и компактная рабочая станция для намотки и проверки сопротивления от 0.01Ома!

• Размер: 90х55х26.5мм
• Выходная мощность: 5 - 70W
• Выходное напряжение: 1 - 8.5V
• Температурный диапазон: 200F - 600F/ 95℃ - 315℃
• Допустимое сопротивление спирали:
  • кантал: 0.15 - 3ohm (вариватт),
  • никель Ni200/ титан Ti: 0.1 - 1ohm, нержавеющая сталь SS316L 0.15 - 3ohm (ТК)
• 510 Коннектор, подпружиненный.
• Работает от аккумулятора 18650 (в комплект не входит)
• Материал: нержавеющая сталь, авиационный алюминий
• Защита от короткого замыкания и переполюсовки аккумулятора

1. Portable multi-functional Box Tab:

1)70W box mod

2)building deck

3)burning coil,ohm reader

4) power for automatic coil jig

2.Building deck/Burning deck can be installed with atomizer, consumer can adjust its system as request

3. Support 0.05-3ohm coil for burning.

4. Resistance test accuracy can be controlled to 0.01ohm

5. With condensation collection ring for collecting condensed fluid aside

6. Spring type 510 thread connected with battery positive electrode

7. Chinese/English language options

8. 5 groups of memory parameters, customer can pre-set the output parameter for different atomizer.

9. Add power curve output mode to ensure good flavor

1. Turn on/ off: Press the power button 5 times continuously within 3 seconds to turn on/ off. 
2. Standby mode: Display will darken in 5 seconds without working, display off in 15 minutes without working , then press any button can bright the screen. 
3. Overtime protection: Working continuously more than 10 seconds, screen show "over time" and stops output. It will restore when you fire it up again. 
4. Low voltage Alarm: Screen will show "Low battery" when voltage is lower than 3.3V, please recharge or replace battery in time. 
5. Switch of two threads: Circuit board will switch automatically and screen will distinguish when singly use vaping port or coil burning port. When both ports are installed by the work piece, press both power fire button "+" "-" button in 3 seconds. 
6. Resistance test: Testing resistance function is prior when alligator clips are installed to the "+" "-" ports. 
7. Resistance testing return to "0": Connect the "+" "-" alligator clips, then resistance will return to 0 when press the fire button 3 times in 2 seconds. 
8. Function transformation: Under standby mode, press power button 3 times continuously within 3 seconds to enter menu mode. "+" "-" works as switch button, enter to confirm it by pressing power button. 
9. Power adjustment: Press "+" "-" can adjust power under standby mode of VW&TC. 
10. Supply sensitivity adjustment
11. Screen display adjustment
12. Initial resistance checking
13. Button lock and unlock
14. Add temperature compensation system
15. Add shortcut key setting
16. Add TCR mode
17. Add power curve output mode
18. Online upgrading
19. Add SN number
20. Overheating protection
21. Battery reverse
22. Short circuit protection
23. Battery protection
24. Anti-dry burning protection